EARTHWORKS _ M30BX
30kHz Battery Powered Measurement Microphone
The M30BX is a cost effective measurement microphone intended for large and small room calibration. The ultra wide frequency response of 9Hz to 30kHz is flat throughout the entire spectrum and results in accurate room calibration using Smaart, MLSSA, SIMM and TEF based systems. The small element yields an omni-directional pattern resulting in a wide pick up area at the front and sides of the microphone capsule.
-
Microphone body opens for replaceable battery access
-
9Hz – 30kHz flat frequency response
-
Omnidirectional polar pattern
-
Handles up to 140dB SPL without distortion
- Microphone body opens for replaceable battery access, with a battery life of 100 hours
- Works with RTA apps by using iPad / iPhone to TRRS to XLR mic cable
- 30kHz frequency response
- Ideally suited for acoustical measurements including loudspeaker design and quality control, sound system setup and troubleshooting, room acoustics, or any application where an accurate free-field measurement microphone is required
- Improved version of the SMAARTMIC™ previously offered by EAW
- Omnidirectional polar pattern
- Flat frequency response, fast impulse response and exceptional polar characteristics
- Used by SMAART™, MLSSA™, Spectrafoo™, TEF™ and RTA in addition to acoustic measurement systems manufactured by dbx, DEQX and others
- Meets or exceeds ANSI Type 1 and applicable IEC 61094 requirements
- Each M Series microphone is delivered with its own calibration chart providing its individually measured open-circuit sensitivity and the frequency response curve
- Electronic Calibration File available
- Operating Temp Range: -20 deg C to +60 deg C ( -4 deg. F to 140 deg. F)
- Storage Temp Range: -40 deg C to +80 deg C ( -40 deg. F to 176 deg. F)
- Humidity: Up to 90%
- Re-calibration recommended every five (5) years
Frequency Response: 9Hz to 30kHz ±1/-3dB
Polar Pattern: Omnidirectional
Sensitivity: 34mV/Pa (-29dBV/Pa)
Power Requirements: 6V Battery Type P28 (2CR-1/3N, 4LR44 or equivalent)
Max Acoustic Input: 140dB SPL
Output: XLR (pin 2+)
Output Impedance: 65Ω balanced (between pins 2 & 3)
Min Output Load: 600Ω between pins 2 & 3
Noise: 20dB SPL equivalent (A weighted)
Dimensions L x D: 220mm x 22mm (8.65 x .860 inches)
Weight: .4 lb. (180g)
.jpg)
.jpg)
